Lifting, carrying and transferring (handling)
- Lifting and carrying a person with a physical disability should be done as little as possible. Whenever possible, move the person in the wheelchair itself.
- When lifting is needed, look at three things: the dignity of the person being lifted, that person's safety, and the lifter protecting his own lower back (back).
Methods of lifting and carrying:
- Before lifting, always tell the person: what you are going to do, how you are going to do it, and what you expect from them.
- Stand as close to the person as possible. Bend the knees, not the waist, and come down to the person's level.
- Lift with one arm under the thighs and the other arm across the back and under the armpit.
- If two people are needed: both bend their knees and hold each other's hands firmly under the thighs and across the back. Decide in advance which direction to move; act together on a signal such as "lift on the count of three". Ask the person being lifted to lean forward as much as possible.
- Transfer: when moving from the wheelchair to a bed, toilet, car, the floor or another chair (or back), always keep the wheelchair as close as possible to that place.
Special furniture: advantages and disadvantages
Some children with CP cannot sit on their own. For many, a table in front is enough. But children who cannot hold the head up or keep the body upright need a special seat.
| Advantages | Disadvantages |
|---|---|
| Gives extra support | Keeps the child in one posture and limits activities |
| The child is more comfortable | The child's size and posture change with time; but furniture is fixed and usually cannot be changed |
| He feels safer (that he will not fall) | Sitting for a long time causes tiredness |
| He can keep a good posture; sitting is stable | A child who stiffens may stiffen more; permanent tightness (contractures) may develop, especially at the hips and knees |
- So check from time to time whether these aids are useful, and change them as needed.
Care in making special furniture
- Give exact measurements to the carpenter.
- In all wooden joints use glue along with nails or screws - it is strong, and urine or spilt liquids do not soak into the joints.
- Before painting, smooth the wooden surface with sandpaper; remove sharp edges and corners.
- Laminated sheets on tables and trays make cleaning easy.
- Painting makes it attractive; use the child's favourite colour.
Measurements for a special seat
Seat the child on a low stool (of a height at which the feet rest flat on the floor). If he cannot sit on his own, hold him seated; keep him as upright as possible.
| Measurement | How to measure |
|---|---|
| Seat length | From the back to where the knee bends (A to B) |
| Seat width | Width of the back (hips) + an extra 2 inches (C to D) |
| Arm supports (sides of the seat) | From the stool to 2 inches above the waist (A to G) |
| Height of the back | From the stool to the top of the shoulders (A to E); if the child cannot hold the head up, from the stool to the top of the head (A to F) |
| Seat height from the floor | With the knees at a right angle and the feet flat on the floor - from the back of the knee to the floor (B to H) |
| Footrest height (if wheels are fitted) | From the back of the heel to the back of the knee |
Types of special furniture
| Furniture | For whom and how |
|---|---|
| Floor seat | For families who sit on the floor at home to eat and play; most suitable for young children. Support at the back and sides. If the head is not steady, the back is made higher. Since it is on the floor, no seat-height measurement is needed |
| Box seat | Like the floor seat, but a little higher for children who do not sit on the floor; the seat height from the floor is also measured. To move it, castors are fitted below, and then a footrest must also be fitted |
| Potty chair | Children who cannot sit or have no sitting balance find it hard to use the toilet. In this chair they can sit without anyone holding them - there is some privacy. It is also useful for children not yet toilet trained. Measurements are like the box seat; the sides are upright up to the shoulders. A rod is passed through two round holes in the sides to keep the child from falling - this rod is at a height from the seat to just below the armpits, 2 inches in front of the chest. A hole in the seat and a bucket below; for boys the hole is pear-shaped. No padding on the toilet seat |
| Ramp seat | For children who slide forward on the seat. The ramp is 2 inches high at the front and slopes gently until, after 1/3 of the seat, it is level with the rest of the seat. Made of plywood, with 1 inch thick foam. More comfortable than a pommel; but if the child still slides, a pommel is needed |
| Pommel | For children with tightness between the two legs, it keeps the legs apart; it stops sliding forward. A cylindrical wooden block 6 inches high and 2 inches in diameter; fitted 1 inch in front of the groin; padded with 1 inch foam and covered with rexine |
| Pelvic strap | Extra support and stability for children who slide forward; safety from falling even when left alone. Fixed at the back of the seat, below the seat level, coming up around the waist - he cannot slide out from under it. A thick cotton strap 2 inches wide, tied in front |
| Padding | Since children sit for long hours in the day, the back, sides and seat should usually all be padded with 1 inch foam. If the child is not toilet trained or spills food, use rexine, which is easy to wipe; if there is a lot of sweating, a towel over the rexine; if there are no such problems, a cloth cover |
| Floor table | For children who sit on the floor; easy to make and takes little space. If sitting is hard, it is a support to lean forward on - the hands can be used well. It encourages children used to sitting with bent knees and folded legs to sit with legs stretched out. It can be used with a floor seat. A raised edge (beading) on the three sides other than the child's side - so that toys do not roll off. Usual size 18 × 18 inches; for young children 15 × 15 inches |
| Cut-out tray | A tray fitted to a chair or wheelchair; support around the trunk for children who fall forward or sideways - the child stays upright and uses the hands well. Fix it to the chair with hooks on both sides. With legs fitted, it becomes a table and can be used with a floor seat. Height a little above the waist; diameter of the semicircular cut-out = waist width + 2 inches; beading on three sides |
- The child is most comfortable in a chair made to his measurements. Whenever possible, take professional advice before making a seat. As the child grows, the size and shape of the seat may need to be changed.
Exam focus: When lifting, bend the knees, not the waist; dignity, safety and the lifter's back. Pommel - 6 inches high, 2 inches in diameter, 1 inch in front of the groin. Ramp - 2 inches at the front, 1/3 of the seat. Pelvic strap - 2 inches wide, fixed at the back below the seat. Floor table 18 × 18 (15 × 15 for young children). Seat width and cut-out - measurement + 2 inches. Long use of special furniture carries a risk of contractures.
Memory code: Pommel "6 - 2 - 1": 6 inches high, 2 in diameter, 1 in front of the groin. "The 2-inch rule": seat width +2, arm support waist +2, cut-out +2, rod 2 in front of the chest, strap 2 wide, ramp 2 high.